Be sure to satisfy proper or other energy storing components provided by Trane equipment grounding requirements per NEC.The installation, starting up, and servicing of heating, ventilating, and air-.
![]() This system describes the product offerings using a product coding block which is made up of feature categories and codes that identifies all characteristics of a unit. Contractor shall provide Trane (or an agent of Trane specifically authorized to perform start-up) with notice of the scheduled start-up at least two weeks prior to the scheduled start-up. Motor Optional unit mounted starter These dimensions per NEC Article 110 3 ft. CVHE-SVX02H-EN. Typical rigging arrangements for Simplex units (continued) units 16 feet (4.8768 meters) minimum effective length Safety chain or cable 800 Short shells only use rigging flange Jack slots Auxiliary option Heat recovery option CVHE-SVX02H-EN. ![]() Important: Immediately report any unit damage incurred during handling or installation at the job site to the Trane sales office. NOTICE: Piping suggestions for each of the water circuits listed. For trouble shooting, a viewable control module has no effect in Trane diagnostic is generated if a proof of flow switch does not application. It is strongly recommended that the piping Whenever a CVHE, CVHF, or CVHG unit is equipped contractor does not run pipe closer than 3 feet with an auxiliary condenser, use a bypass valve system (0.91 meters) minimum to the equipment. These sensor extension cables may be necessary if the waterboxes are changed or if the temperature sensors are moved out into the unit piping for better mixed temperature readings. Flange adapters are not provided for CVHE, Waterbox Waterbox Water Box Water Box CVHF, or CVHG units with 300 psig or 2068.4 kPaG waterboxes that have 14 in. Waterside design pressure is either 150 or 300 psig (1034.2 or 2068.4 kPaG); refer to unit nameplate or to submittal documentation. Provide a vent line termination that cannot be blocked by debris or accumulate rainwater. All vent- lines must be equipped with a drip leg of sufficient Purge discharge volume to hold the expected accumulation of water vent line and or refrigerant. Vent line size is typically dictated by state or local code which may be different from ASHRAE Standard 15 requirements. Factory-installed insulation is available as an option for all units. Factory installation does not include insulation of Note: If the unit is not factory-insulated: install insulation the chiller feet. Trane Cvhe Chiller Troubleshooting Free Elbow CoolingLine from evap Filter drier and eductor lines Suction Suction cover Pipe (free elbow cooling only) Suction Control connection panel support Pipe Economizer Eductor line Pipe See Notes See Notes See Note Evaporator CVHE-SVX02H-EN. Figure 25 shows the locations of each LED and Table 11, p. Standard control panel: Tracer AdaptiView main unit assembly (showing low voltage and higher voltage areas for proper routing of field wiring) 30 Volt Maximum 30115 Volt Maximum CVHE-SVX02H-EN. To adjust the leftright swivel of the entire display arm, use a 13 mm wrench to adjust the bolt labeled 4 in Figure CVHE-SVX02H-EN.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |